Spine Surg Relat Res. 2021 Jan 12;5(4):278-283. doi: 10.22603/ssrr.2020-0189. eCollection 2021.
ABSTRACT
INTRODUCTION: Previous studies have reported differences in lumbopelvic alignment between standing and supine positions. Computed tomography (CT) images taken in the supine position are often used for clinical studies in addition to standing radiographs, although not frequently. Our study aims to clarify normative values of CT-evaluated lumbopelvic parameters and the characteristics of age- and gender-related lumbopelvic alignment in the supine position.
METHODS: Patients undergoing CT scans of abdominal or lumbar regions for reasons other than low back disorders were included (n=581). Sagittal multiplanar reconstruction CT images were obtained, and lumbar lordosis (LL), L5-S1 angle, and sacral slope (SS) were measured. Mean values of the parameters in patients aged 59 years and under, 60-69, 70-79, and 80 and over, and in males and females, were calculated. Age- and gender-related differences in these parameters were statistically analyzed.
RESULTS: Among the four age groups, patients 80 years and over showed significantly lower LL and SS than patients aged 70-79. Females 80 years and over showed significantly lower LL and SS than all other age groups, but those in males did not. The comparison between males and females showed no significant differences in LL and SS; however, the L5-S1 angle was significantly higher in males than in females. In patients 80 years and over, females showed significantly lower LL and SS than in males.
CONCLUSIONS: This study provides normative CT-evaluated lumbopelvic parameters, such as LL, L5-S1 angle, and SS, which will be utilized for comparisons in future studies. The present study first revealed that pelvic retroversion and lumbar kyphosis occur in elderly females in the supine position, which raised a possibility that age-related decrease of LL and SS in females occurs at an older age in the supine position than in the standing position.
PMID:34435152 | PMC:PMC8356231 | DOI:10.22603/ssrr.2020-0189
