J Mech Behav Biomed Mater. 2021 Apr 3;119:104503. doi: 10.1016/j.jmbbm.2021.104503. Online ahead of print.
ABSTRACT
This in vitro study used the same frequency and duration of acid contact as a previous in situ/in vivo study to evaluate the effect of erosion on CAD/CAM restorative materials and human enamel and to compare the effects of in vitro and in situ/in vivo acid challenges on CAD/CAM restorative materials and human enamel. The CAD/CAM restorative materials (IPS e.max CAD, Lava Ultimate, and PMMA block) and human enamel were eroded by immersion in 150 ml of cola drink for 14 days (4 × 5 min/day). The surface microhardness and surface roughness of the specimens were measured at baseline (T1), day 7 (T2), and day 14 (T3). The substance losses were measured at T2 and T3. The data were statistically analyzed using repeated measures ANOVA and Bonferroni’s test (α = 0.05). Erosion significantly decreased the surface microhardness of the CAD/CAM restorative materials and human enamel (all P < 0.001). The overall percentage of surface microhardness loss (%SMHl) of the PMMA block and enamel due to in vitro erosion was significantly higher than that due to in situ/in vivo erosion (P = 0.02 and P < 0.001, respectively). Consistent with in situ/in vivo erosion, the surface roughness and profile of the tested restorative materials remained unchanged after in vitro erosion. A significant increase in the surface roughness and substance loss was observed for enamel after in vitro erosion (all P < 0.001). The overall substance loss of enamel due to in vitro erosion was significantly higher than that due to in situ/in vivo erosion (P < 0.001). In conclusion, erosion decreased the surface microhardness of the CAD/CAM restorative materials and human enamel. Moreover, erosion negatively influenced the substance loss and surface roughness of human enamel. For the substance loss of enamel and %SMHl of PMMA block and enamel, the in vitro erosive effects were approximately 1-2 times greater than the in situ/in vivo effects. However, for the surface roughness and profile of the CAD/CAM restorative materials, no significant difference was found between in vitro and in situ/in vivo erosion.
PMID:33845297 | DOI:10.1016/j.jmbbm.2021.104503